Adding nickel enhanced the tensile ductility and toughness of a steel that was formulated to be strong and impact-resistant.
Recent Issue
Ferroloy's New Direction
July 19, 2019Within two years, the gray and ductile iron foundry diversified its markets, doubled its staff and became nearly silica-free.
Read MoreConversations on Capitol Hill
Metalcasters convened in Washington, D.C., to ask for investment in infrastructure and legislation that supports U.S. manufacturing.
Synergistic Effects of Coatings, Additives in PUCB Systems
Sand additives and refractory coatings are essential components in reducing or eliminating casting defects, therefore proper combination of both the type and the level of these components are necessary to achieve optimal results.
Putting It All Together
Assembly can be a valuable part of a foundry’s portfolio, but it brings challenges and might not fit every metalcaster.
Featured Content
PSU Behrend Students Learning Value of Internships
What is the value of an internship program at a metalcasting facility? What does an intern do? Who benefits from an internship program?
AFS Applauds Introduction of Made in America Act
In June, the Made in America Act, strengthening Buy America requirements, was introduced in both chambers.
Too Much Is Just Too Much
We all want to melt metal quickly in our foundries, but a high fire rate with your furnace burners doesn’t necessarily improve your melt rate. When we over-fire the furnace, energy efficiency is extremely poor and melt loss can be worse.